Owners manual

CG- 211C TORCH BURNER MACHINE
7
Ø The machine has a forward/reverse directional toggle switch located on the main control panel.
o NOTE: There is also a neutral position for this switch in between the positions.
Ø The variable speed switch will increase of decrease the machine speed. 0 symbolizing no
movement and 10 symbolizing fast movement.
Ø The power control box cord connection point is where the black power cord plugs in from the
control box.
o NOTE: Make sure to line up the half round notch in plug with the half round piece in the
plug input.
Ø The control box converts the AC current coming in from external power to DC, which is used by
the main machine motor.
o The main power control box has a power indicator light (which indicates the control box
has AC power connected), an electrical fuse and a main on/off switch.
o CAUTION: Do not remove the fuse unless the power control box is disconnected from
the power source.
§ When the main on/off switch is in the “on” position it is sending DC power to the
machine.
§ When the main on/off switch is in the “off” position it is not sending power to the
machine.
SETTING UP THE MACHINE
Ø Install the main spreader bar and the torch holder assembly.
o Tighten the appropriate wing-nuts.
Ø Install the torch holder into the torch holder assembly.