Owners manual

MODEL 945- VS WIRE STRIPPING MACHINE
8
WIRE GUIDE DIAGRAM
RUNNING WIRE
Ø Do all pre-operational and operational safety checks from Chapter 1.
Ø After securing the machine, plug the machine into power source.
Ø Have your wires ready to process, by separating them by type and cutting them into
3-4’ lengths.
o This is primarily for safety, but also to protect the motor from torque created
by pulling heavy wires into the machine.
Ø Go through the on/off functions to make sure they are operating correctly. Start the
machine by pressing the green “on” switch. Stop the machine by pressing the red
“off” switch.
o Once the green motor starter switch is on, the invertor will activate and the
motor fan will start and the invertor will start blinking.
o Press the run button and the machine will start turning.
§ NOTE: if you need the machine to stop quickly in an emergency, press
the red “stop” button on the TEKO motor starter (not the invertor). If
you press the invertor stop button, it will stop slowly.
o Turn the knob on the invertor to speed up or slow down the speed.
§ If stripping larger, thicker, or rubbery jacketed wire, it is recommended
to slow the machine down to assist cutting through the entire jacket.
Ø Select a wire to strip.
Ø Decide on which guide is the correct guide input.
Ø Run the wire through.
o If the wire did not cut through the complete jacket, run it through again
through a smaller channel.