Owners manual

10”Z1RB CORE DRILL
7
are the black hex bolts on the side and back of the machine that have a locking nut around them. These
are generally used to tighten up the travel as the slides wear over time. Be mindful to evenly adjust these
so that the travel is even and smooth. The ideal travel generally keeps the drill in place when the user is
not using the drill (this is usually on the tighter side) although individual users needs may vary. The side
black carriage bolt can also be used for temporarily locking the carriage in place.
1) Motor Brush Holder
2) Motor On/Off Switch
3) Top Bolt for Binding in Ceilings
4) Drill Motor
5) Carriage Adjusting Bolts
6) Black Frame Handle
7) Drill Carriage
8) Feed Handle
9) Gearbox
10) Spindle
11) Drill Stand
12) Coring Bit (not included)
13) Stand Base
14) Base Wheels
TRANSPORTING THE MACHINE
Ø When transporting the machine, always use two hands.
Ø DO NOT transport the machine with bits in the spindle.
Ø When using the wheels, tilt the machine back towards the operator and once the wheels are engaged with
the ground pull or push the machine on the ground.
Ø If transporting inside a vehicle, it is recommended to transport it on its side so as to avoid the item falling
over.
Ø DO NOT carry/pull the machine by the cord.
Ø DO NOT allow the cord or plug to drag along the floor when transporting.