Data Sheet

10/10/2018 Fathom Spool Documentation
http://docs.bluerobotics.com/spool/#specifications 12/19
Mount the spool assembly to the partially assembled rst frame half, and then use six threadlocked M4x20 screws and a
2.5 mm hex driver to capture the assembly by completing the frame with the second frame panel. The spool assembly
can be mounted in either orientation so that the crank handle can be on either side according to personal preference.
Pictured is the left handed cranking orientation. Note the round handle goes to the rounded tip at the top of the frame.
Tighten the screws until they indent the plastic slightly.
Step 9: Securing the Slip Ring Core