Data Sheet

7/31/2018 Lumen Light R2
http://docs.bluerobotics.com/lumen-r2/ 3/6
SolidWorks Part (.sldprt)
IGES (.igs)
STEP (.step)
STL (.stl)
Lumen Light 
Lumen Light R2 Assembly LUMEN-ASM-LIGHT-R2.zip (/lumen-r2/cad/LUMEN-ASM-LIGHT-R2.zip)
Installation
The Lumen Light can be easily installed using the included threaded M3 mounting holes.
Using the Threaded Holes
The two threaded holes are best used when you have access to install a screw that tightens into the holes. This applies to most
ROVs. Note that the threaded holes have the same size and spacing as the thruster mounting holes so you can use a thruster
mounting bracket or hole pattern.
1. Drill two holes between 3.1mm and 3.3mm (0.12-0.13”) in diameter 19mm (0.75”) apart on the part you wish to mount the
light.
2. Install two M3x0.5 screws through the holes that you just drilled. We recommend 316 stainless steel screws and they should
be roughly 1.5 - 3.0mm longer than the thickness of the part that you are mounting to. Optional: Apply a small dab of
Medium-strength (blue) threadlocker such as Loctite 243 to the M3 screws.