Datasheet

TSYS01-FAMILY
Digital Temperature Sensor
SENSOR SOLUTIONS /// TSYS01-FAMILY
06/2018
Page 6
PROM READ SEQUENCE
The PROM Read command consists of two parts. First command sets up the system into PROM read
mode. The second part gets the data from the system.
Below examples are sequences to read address 3 (command 0xA6).
SPI
I
2
C
CONVERSION SEQUENCE
A conversion has to be started by sending this command. The sensor stays busy until conversion is done.
When conversion is finished the data can be accessed by using ADC read command
SPI
The last clock will start the conversion which TSYS01 indicates by pulling SDO low. SDO goes high when
conversion is completed.