Data Sheet

2/7/2019 Ping Installation Guide for the BlueROV2 - Blue Robotics
https://www.bluerobotics.com/learn/ping-installation-guide-for-the-bluerov2/ 7/21
(/wp-content/uploads/2019/01/ping-end-cap-remove.jpg?x68454)
Install Ping Penetrator 
To install Ping into the end cap, you will need the following parts and tools:
1 x Ping Echosounder
1 x Penetrator Nut (Red)
1 x Penetrator O-ring
1 x Silicone Grease – 10g Tube
1 x Isopropyl Alcohol Wipe
1 x Penetrator wrench
1. Wipe the exterior surface of the electronics enclosure endcap clean with isopropyl alcohol or isopropyl alcohol wipes, and make sure it is
free of any particles in the areas where the penetrator O-ring will sit.
2. Remove the O-ring from the bag and apply silicone grease to it.