PTAC Owners Manual

WARNING

BAFFLES

RETRO FIT SLEEVE PREPARATION

IMPORTANT: Inspect wall sleeve thoroughly prior to installation. Manufacturer does not

assume responsibility for costs or damages due to defects in sleeve or for improper installation.

ELECTRI CAL SHOCK HAZARD

Failure to follow this warning could result in personal injury

or death.

Disconnect all power to unit to avoid possible electrical

shock during installation.

Remove any existing foam baffles that are installed on competitive outdoor grille, if present. See Fig. 5.

GE Sleeves Only

GE Meta l Wall Sleeve -GE metal sleeve is interchangeable with Blueridge wall sleeve. See Fig. 6.

GE Plastic Sleeve -- Remove bottom seal from plastic sleeve. See Fig. 7.

INSTALLATION OF A Blueridge OR CARRIER WALL SLEEVE USING A NON-Blueridge GRILLE

This application has become more common due to pre--manufactured windows with built--in grilles or

renovations where a Blueridge or Carrier sleeve is used with an existing non -- Blueridge grille.

Use of a Blueridge or Carrier wall sleeve with a non--Blueridge grille requires installation of an Accessory

Baffle Kit (see Fig. 8), which ensures a good seal between the unit and exterior grille to prevent air recirculation.

Air recirculation is a large contributor to performance loss and and premature damage to major components.

Notes: Blueridge stamped grille is interchangeable with CARRIER'S.

Fig. 5 – Remove Existing Outdoor Grille Baffles on

Competitive Grille

Fig. 6 – GE Metal Sleeve

Fig. 7 – Remove Bottom Seal From GE Plastic Sleeve

Fig. 8 – Accessory Baffle Kit

Note: contact your units supplier to get the kit and it

may be different from the shape showed above.