BMKH18M-NDG3 & BMKH30M-NDG3 Owners and Installation Manual

Blueridge Owners Manual

Document Version: 11/2016

Band the copper lines, wire, and drain hose

Hang the Indoor Air Handler

• Bind the copper lines, the multi-

conductor wire, and drain hose

up with a band as seen in Img 5.

• Take into consideration that

the drain tubing will not run the

entire distance as the copper

lines, so allow the drain tubing

to escape this binding where the

contractor sees fit.

• Feed the bound pipes through the wall sleeve or piping hole.

• Hang the indoor air handler on the wall mounting frame.

• Use sealing gum or expanding foam to ensure there is no air exchange

between the wall sleeve or piping hole and the exterior of the space. This

should be a very tight seal.

• Ensure the indoor air handler is firmly installed on the wall.

Band or

Duck Tape

Line Sets and

Interconnective Wires

Drain Pipe

Img 5 | Banding wires

Installation of the Indoor Air Handler