Installation & Owners Manual 2017

Blueridge Owners Manual

Document Version: 01/2017

Band the copper lines, wire, and drain hose

Hang the Indoor Air Handler

• Wrap the copper lines, the mul-

ticonductor wire, and drain hose

up with tape as seen in Img 5.

• The drain tubing does not need

to run the same distance as the

copper lines. The drain tubing

can exit the wrapping at any

appropriate drainage location as

shown in Image 5.

• Feed the wrapped pipes through the wall sleeve or piping hole.

• Hang the indoor air handler on the wall mounting frame.

• Use caulk or expanding foam to ensure there is no air exchange between

the wall sleeve or piping hole and the exterior of the space. This should

be a very tight seal.

• Ensure the indoor air handler is firmly installed on the wall.

Band or

Duck Tape

Line Sets and

Interconnective Wires

Drain Pipe

Img 5 | Banding wires

Installation of the Indoor Air Handler