U-Match Single Zone Installation Manual
Table Of Contents
- Slide Number 1
- Slide Number 2
- Slide Number 3
- Slide Number 4
- Slide Number 5
- Slide Number 6
- Slide Number 7
- Slide Number 8
- Slide Number 9
- Slide Number 10
- Slide Number 11
- Slide Number 12
- Slide Number 13
- Slide Number 14
- Slide Number 15
- Slide Number 16
- Slide Number 17
- Slide Number 18
- Slide Number 19
- Slide Number 20
- Slide Number 21
- Slide Number 22
- Slide Number 23
- Slide Number 24
- Slide Number 25
- Slide Number 26
- Slide Number 27
- Slide Number 28
- Slide Number 29
- Slide Number 30
- Slide Number 31
- Slide Number 32
- Slide Number 33
- Slide Number 34
- Slide Number 35
- Slide Number 36
- Slide Number 37
- Slide Number 38
- Slide Number 39
- Slide Number 40
- Slide Number 41
- Slide Number 42
- Slide Number 43
- Slide Number 44
- Slide Number 45
- Slide Number 46
- Slide Number 47
- Slide Number 48
- Slide Number 49
- Slide Number 50
- Slide Number 51
- Slide Number 52
- Slide Number 53
- Slide Number 54
- Slide Number 55
- Slide Number 56
- Slide Number 57
- Slide Number 58
- Slide Number 59
- Slide Number 60
- Slide Number 61
- Slide Number 62
- Slide Number 63
- Slide Number 64
- Slide Number 65
- Slide Number 66
- Slide Number 67
- Slide Number 68
- Slide Number 69
- Slide Number 70
- Slide Number 71
- Slide Number 72
- Slide Number 73
- Slide Number 74
- Untitled
Temperature compensation selecting
Cassette Units Duct Units Ceiling & Floor Console Special Tips
Service Space Body Installation Drainage Installation Pre-settings Panel Installation
Micro-switch SW6 is for selection of temperature compensation in
heating mode. This helps to reduce the real temperature difference
between ceiling and floor so that the unit could run properly. If the
height of installation is lower, smaller value could be chosen.
Range: 6
o
C, 4
o
C, 2
o
C, E function (reserved for special customizing)