BG802DF Installation Instructions
Table Of Contents
- BG802DFE Gas Furnace
- Unit Dimensions
- Parts Arrangement
- Shipping and Packing List
- Safety Information
- General
- Combustion, Dilution & Ventilation Air
- Downflow Installation
- Filters
- Duct System
- Venting
- Gas Piping
- Electrical
- Integrated Control DIP Switch Settings
- On-Board Links and Diagnostic Push Button
- Unit Start-Up
- Other Unit Adjustments
- Heating Sequence of Operation
- Service
- Repair Parts List
- Blower Performance
508145-01BPage 34 of 36 Issue 2108
12. If a leak is detected, shut gas and electricity o and repair leak.
13. Repeat steps 12 and 13 until no leaks are detected.
14. Replace access panel.
Manifold And Gas Valve
Retention Rings
Cross Over
Ignitor
Sensor
Rollout
Switches
Figure 25. Burner Removal
Heating Parts
• Flame sensor
• Heat exchanger assembly
• Gas manifold
• Combustion air inducer
• Gas valve
• Main burner cluster
• Main burner orices
• Pressure switch
• Ignitor
• Primary limit control
• Flame rollout switch (s)
• Secondary limit
Repair Parts List
The following repair parts are available through
independent Blue Summit dealers. When ordering parts,
include the complete furnace model number listed on
the CSA International nameplate. All service must be
performed by a licensed professional HVAC installer (or
equivalent), service agency, or gas supplier.
Cabinet Parts
• Main access panel
• Blower panel
• Top cap
Control Panel Parts
• Transformer
• Integrated control
• Door interlock switch
• Circuit breaker
Blower Parts
• Blower wheel
• Blower housing
• Motor
• Motor mounting frame
• Motor capacitor
• Blower housing cuto plate