User's Guide

Page 18 of 19
nBlue Bluetooth 5.0 Module User’s Guide
Copyright © 2002-2019 BlueRadios, Inc.
8310 S. Valley Highway, Suite 275 • Englewood, CO 80112 • USA • 303-957-1003 • [e-mail]
www.BlueRadios.com
5 Regulatory Information
5.1 United States (FCC) Notices
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
5.1.1 FCC RF Exposure Guidance
In order to comply with FCC/ISED RF Exposure requirements, this device must be installed to provide at least
20 cm separation from the human body at all times.
5.1.2 FCC Labelling Requirements
If the FCC ID on the module is not visible once integrated into another device, then a label visible on the
outside of the host device must contain the following statement: Contains FCC ID: XDULE50-S1A
5.2 Canada (IC) Notices
5.2.1 User Manual Notice for Licence‑Exempt Radio Apparatus
User manuals for licence‑exempt radio apparatus shall contain the following or equivalent notice in a
conspicuous location in the user manual or alternatively on the device or both.
This device complies with Industry Canada licence‑exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne
doit pas produire de brouillage; (2) l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
5.2.2 ISED RF Exposure Guidance
In order to comply with FCC/ISED RF Exposure requirements, this device must be installed to provide at least
20 cm separation from the human body at all times.
Afin de se conformer aux exigences d'exposition RF FCC / ISED, cet appareil doit être installé pour fournir au
moins 20 cm de séparation du corps humain en tout temps.