Tus neeg siv phau ntawv
BlueParrott B450-XT User Manual
PAGE 9
Manual Pairing
If the B450-XT has already been paired with another device and you are not going to
use NFC Pairing, you will need to put it into Pairing Mode manually:
Placing Headset into Pairing Mode
By Voice:
Activate headset voice recognition by pressing the Parrott Button or by pressing and
holding the Volume Up button. Then, after the prompt, say “pair mode.” The headset
will enter pairing mode and be visible for pairing to devices for 120 seconds.
Using Buttons:
With the headset powered off, press and hold the MFB until you hear “Power on”. Keep
holding the MFB for approximately 6 seconds until the LED flashes alternating blue
and red, or you hear “Pair mode”. The headset will be visible for pairing to devices for
120 seconds.
Pairing to a Cell Phone
1. Make sure that other Bluetooth devices are turned off or out of range.
2. Place the headset into pairing mode.
3. Put your cell phone in Bluetooth Search/Scan Mode per the manufacturer’s
instructions.
4. Select “BlueParrott B450-XT” to pair. (Passcode is “0000” if needed.)
5. Accept the phone book access request to enable caller ID in the headset.
6. When connected, the headset will give you the voice prompt, “Your headset is
connected.”
GETTING STARTED (continued)
BlueParrott B450-XT User Manual
PAGE 10
HOW TO WEAR AND ADJUST THE B450XT
Adjusting the headband length
For a more comfortable and secure fit, the headband length can be adjusted as
illustrated below: