User`s manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Advanced Viewing Setup
- Chapter 4 Web-based Management
- Introduction
- Connecting to IVS-100
- Welcome Screen
- Viewing Area
- Control Panel Screen
- Advanced Configuration Area
- IVS-100 Advanced setting Menu
- System Screen
- Camera Screen
- Network Screen
- User Screen
- IP Filter Screen
- FTP Client Screen
- SMTP Screen
- Alarm 1 & Alarm 2 Screen
- Schedule Screen
- Motion Detection Screen
- Time Setting Screen
- Popup Screen
- Firmware upgrade Screen
- Factory Default Screen
- ActiveX Control
- Appendix A Alarm I/O Connector
- Appendix B Troubleshooting
- Appendix C Bandwidth Calculation
- Appendix D Specifications
6. The upgrade progress status information will be displayed on the screen. Once
the upgrading process completed, the Video server will reboot the system auto-
matically.
Do not interrupt the upgrading procedure during proceeding; or
the inner component might be permanently damaged.
L Hint
Factory Default Screen
This screen is displayed when you click the Factory Default menu on the Status
screen.
Please Click “OK” button to load default settings to camera.
Trigger & Capture
Trigger:
This is sending an image or output a trigger to control the alarm output, using Trigger
section on the main page.
38