User`s manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Advanced Viewing Setup
- Chapter 4 Web-based Management
- Introduction
- Connecting to IVS-100
- Welcome Screen
- Viewing Area
- Control Panel Screen
- Advanced Configuration Area
- IVS-100 Advanced setting Menu
- System Screen
- Camera Screen
- Network Screen
- User Screen
- IP Filter Screen
- FTP Client Screen
- SMTP Screen
- Alarm 1 & Alarm 2 Screen
- Schedule Screen
- Motion Detection Screen
- Time Setting Screen
- Popup Screen
- Firmware upgrade Screen
- Factory Default Screen
- ActiveX Control
- Appendix A Alarm I/O Connector
- Appendix B Troubleshooting
- Appendix C Bandwidth Calculation
- Appendix D Specifications
To use camera tour function, the camera should be connected
the RS485 connector, and the external camera should be sup-
ported by Video server. Users must preset some camera posi-
tions first. The maximum number of preset points is 16.
In Camera Tour page, choose the one tour name from A to E. Fill
the dwelling time and tour sequence by preset points, and then
save these setting. You can repeat above procedure to set more
camera tours.
L Hint
Network Screen
This screen is displayed configure Network setting such as IP address, DHCP, DDNS
and PPPoE.
Network screen
Data - Network Screen
Network Settings
DHCP
Enable or disable DHCP client in IVS-100
IP address,
Subnet mask,
Default gate-
way, Primary
DNS, Secon-
dary DNS
This parameter allows users to setup the IP address assigned by
ISP. Your ISP should provide all the information requied for
Internet access.
Note: User need to reboot the Video server to make this setting
to take effect.
HTTP Port 1,
HTTP Port 2
Users could assign the port number of http protocol, and the
WAN users should follow the port number to login.
26