User`s manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Advanced Viewing Setup
- Chapter 4 Web-based Management
- Introduction
- Connecting to IVS-100
- Welcome Screen
- Viewing Area
- Control Panel Screen
- Advanced Configuration Area
- IVS-100 Advanced setting Menu
- System Screen
- Camera Screen
- Network Screen
- User Screen
- IP Filter Screen
- FTP Client Screen
- SMTP Screen
- Alarm 1 & Alarm 2 Screen
- Schedule Screen
- Motion Detection Screen
- Time Setting Screen
- Popup Screen
- Firmware upgrade Screen
- Factory Default Screen
- ActiveX Control
- Appendix A Alarm I/O Connector
- Appendix B Troubleshooting
- Appendix C Bandwidth Calculation
- Appendix D Specifications
Image, Rotate,
Mirror, Focus
Mode, White
Balance
These functions are reserved for future product developing.
They are not functional in IVS-100.
Saturation,
Sharpness,
Contrast, Hue
Key in respective value for image adjustment. It is not required
to adjust this value when the image is vivid.
Camera Tour
To use IVS-100 tour function, user must preset some camera
positions first.
Select the “SET Tour” button to enter IVS-100 Tour setting
page.
Reset to De-
fault
Restore the values of these pages to factory default value.
Camera Tour
In the camera tour page, choose the one tour name. Fill the dwelling time and tour
sequence by preset points, can repeat above procedure to set more camera tours.
Camera Tour Screen
Data – Camera Tour Screen
Camera Tour Settings
Tour Name
Choose the one tour name from A to E
Dwelling Time
The time period between every tour point.
Sequence
16 points can be assigned.
Enable
Enable camera tour group should be activated
25