User`s manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Advanced Viewing Setup
- Chapter 4 Web-based Management
- Introduction
- Connecting to IVS-100
- Welcome Screen
- Viewing Area
- Control Panel Screen
- Advanced Configuration Area
- IVS-100 Advanced setting Menu
- System Screen
- Camera Screen
- Network Screen
- User Screen
- IP Filter Screen
- FTP Client Screen
- SMTP Screen
- Alarm 1 & Alarm 2 Screen
- Schedule Screen
- Motion Detection Screen
- Time Setting Screen
- Popup Screen
- Firmware upgrade Screen
- Factory Default Screen
- ActiveX Control
- Appendix A Alarm I/O Connector
- Appendix B Troubleshooting
- Appendix C Bandwidth Calculation
- Appendix D Specifications
4
Chapter 4
Web-based Management
This Chapter provides Setup details of the IVS-100’s Web-based Inter-
face. This Chapter is for Administrators only.
Introduction
The IVS-100 can be configured using your Web Browser. The IVS-100 must have an
IP address, which is compatible with your PC.
Connecting to IVS-100
• If you have run the CamView utility, the screen provided a button . Clicking
this button will immediately connect to the IVS-100.
• If using only your Web Browser, use the following procedure to establish a con-
nection from your PC to the IVS-100:
• Once connected, you can add the IVS-100 to your Browser's Favorites or Book-
marks.
Connecting using your Web Browser
1. Start your web browser.
2. In the Address box, enter "HTTP://" and the IP Address of the IVS-100, as in this
example, which uses the IVS-100's default IP Address:
HTTP://192.168.0.20
3. Default username/password for machine login: admin/ <no password>
4. If the Administrator ID and Password have been assigned, enter the name and
password you assigned.
18