User`s manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Advanced Viewing Setup
- Chapter 4 Web-based Management
- Introduction
- Connecting to IVS-100
- Welcome Screen
- Viewing Area
- Control Panel Screen
- Advanced Configuration Area
- IVS-100 Advanced setting Menu
- System Screen
- Camera Screen
- Network Screen
- User Screen
- IP Filter Screen
- FTP Client Screen
- SMTP Screen
- Alarm 1 & Alarm 2 Screen
- Schedule Screen
- Motion Detection Screen
- Time Setting Screen
- Popup Screen
- Firmware upgrade Screen
- Factory Default Screen
- ActiveX Control
- Appendix A Alarm I/O Connector
- Appendix B Troubleshooting
- Appendix C Bandwidth Calculation
- Appendix D Specifications
Setup
Initial setup can be performed either from the web browser or using the supplied Win-
dows-based camera utilities. This program can locate the IVS-100 even if its IP ad-
dress is invalid for your network. You can then configure the IVS-100 with appropriate
TCP/IP settings for your LAN.
Subsequent administration can be performed with your Web browser, as explained in
Chapter 3 - Web-based Administration.
Setup Procedure
Before setup operations
The IVS-100 provides GUI (Web based, Graphical User Interface) for machine man-
agement and maintenance.
To start IVS-100 web configuration, the requirement of the web browser should be:
Microsoft Internet Explorer 6.0 or higher with Java support
Current firmware supports Microsoft Internet Explorer, the Netscape
Navigator support is planned in the future firmware release
L Note
Default LAN interface IP address of IVS-100 is 192.168.0.20. You may now open your
web browser, and insert http://192.168.0.20 in the address bar of your web browser to
logon IVS-100 web configuration page.
IVS-100 will prompt for User Name and Password, please enter: admin as username
to continue machine Web Management.
Or you may execute IPEditV3 to discover/edit IP address of IVS-100.
Procedures of IPEdit utility
• Please find the IPEditV3.exe in the Utility folder on user’s manual CD
• Double-click the IPEditV3.exe and the following screen should be prompt on your
computer.
• Choose the destination camera for IP address and device name modifications
9