User`s manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Advanced Viewing Setup
- Chapter 4 Web-based Management
- Introduction
- Connecting to IVS-100
- Welcome Screen
- Viewing Area
- Control Panel Screen
- Advanced Configuration Area
- IVS-100 Advanced setting Menu
- System Screen
- Camera Screen
- Network Screen
- User Screen
- IP Filter Screen
- FTP Client Screen
- SMTP Screen
- Alarm 1 & Alarm 2 Screen
- Schedule Screen
- Motion Detection Screen
- Time Setting Screen
- Popup Screen
- Firmware upgrade Screen
- Factory Default Screen
- ActiveX Control
- Appendix A Alarm I/O Connector
- Appendix B Troubleshooting
- Appendix C Bandwidth Calculation
- Appendix D Specifications
5. Check the LEDs
When powering on machine, the status LED will turn green. It means the system is
booting up successfully. Furthermore, if you have a proper network connection, and
access to the IVS-100, the 10/100M LAN LED will flash orange
6. Connect the RS485 interface
When users would like to apply a camera with Pan / Tilt function, they usually need
to connect their communication port (for camera control) through RS485. After
RS-485 securely connected to D+ and D-, the remote users could control IVS-100
through Internet.
8