User`s manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Advanced Viewing Setup
- Chapter 4 Web-based Management
- Introduction
- Connecting to IVS-100
- Welcome Screen
- Viewing Area
- Control Panel Screen
- Advanced Configuration Area
- IVS-100 Advanced setting Menu
- System Screen
- Camera Screen
- Network Screen
- User Screen
- IP Filter Screen
- FTP Client Screen
- SMTP Screen
- Alarm 1 & Alarm 2 Screen
- Schedule Screen
- Motion Detection Screen
- Time Setting Screen
- Popup Screen
- Firmware upgrade Screen
- Factory Default Screen
- ActiveX Control
- Appendix A Alarm I/O Connector
- Appendix B Troubleshooting
- Appendix C Bandwidth Calculation
- Appendix D Specifications
2
Chapter 2
Basic Setup
This Chapter provides details of installing and configuring the IVS-100.
System Requirements
• To use the LAN interface, a standard 10/100BaseT hub or switch and network
cable is required.
• System Requirement for Viewer & Recorder:
System Hard-
ware
1-4 cameras surveillance application
• CPU: Pentium III, 800 MHz or above
• Memory Size: 128 MB (256 MB recom-
mended)
• VGA card resolution: 1024 x 768 or above
4 or more cameras surveillance application
• CPU: Pentium 4, 1.7G MHz or above
• Memory Size: 512 MB or above
• VGA card resolution: 1024 x 768 or above
Note: The listed information is minimum system requirements
only. Actual requirement will vary depending on the nature of
your environment.
L Hint
6