Instruction manual

 How do I find out my IP address information if my settings were

automatically detected?

• Windows 98 / ME Users

① Open an MS-DOS Prompt

② At the prompt type: “winipcfg” (without the quotes)

③ Use the drop down list to select your 10/100 Ethernet Adapter (not a PPP adapter)

④ Now you will see your IP Address, Subnet Mask, and Default Gateway information

⑤ For DNS information contact your Internet Service Provider

• Windows 2000 / XP Users

① Open a Command Prompt

② At the prompt type - “ipconfig /all” (without the quotes)

③ Near the end of the information supplied, should be your current IP address, subnet mask, default

gateway and DNS servers

 How do I choose a private IP address:

Assign your NVS a private IP address that matches your current network. Below lists the ranges for

private addresses:

• Private Class A address space : 10.0.0.0 - 10.255.255.255

• Private Class B address space : 172.16.0.0 - 172.31.255.255

• Private Class C address space : 192.168.0.0 - 192.168.255.255

 My POWER light is not on?

Power is not being supplied to the unit. Please use the power supply shipped with the unit and verify

that a power source is active from the attached power outlet used to connect the adapter. You can

test this by plugging in any other electrical device and verify its operation. After using the power

supply shipped with the product, checking the power source, and reinserting the power connector

into the NVS, please call our Support Center. The power supply may be defective.

 My ACTIVE light is not flashing?

Verify the power supply to the unit. Power off the unit and back on again, wait 1 minute, if the

ACTIVE light still does not begin to flash, you will have to set the unit to its factory default (THIS

WILL DELETE ANY CONFIGURATION AND SET THE UNIT TO THE FACTORY DEFAULTS).

Power on the unit and insert the end of a paper clip into the small recessed opening on the back of

the unit. Use the clip to press the button located within that opening.

etwork Video Server User’s Manual

B01