Instruction manual

NETWORK SETUP

Port Forwarding

After entering the correct TCP/IP settings you will be ready for “Port Forwarding” (Cases A, B).

 Please record the TCP/IP settings of your NVS for future reference. You may need this information to

access your NVS and to configure “Port Forwarding”. In Case F, please contact your ISP with regard

to Port Forwarding.

NVS TCP/IP Settings

IP Address

Subnet Mask

Default Gateway

Primary DNS Server

DDNS Server

Web Server Port

Video Server Port

 After clicking “Apply” the system will prompt for a reboot. Please allow the system 30

seconds to reboot and accept the changes. After 30 seconds, close the configuration

screen. The view will display “Trying to Reconnect”. If the ACTIVE light on the NVS has

went off and is now back on again flashing, then the NVS has rebooted. After the

system reboots completely, remove the power supply from the unit and close Internet

Explorer.

 Return your PC/Laptop TCP/IP properties to their original settings.

 Before installing the NVS, you must use “Port Forwarding” on your personal router (Cases A, B).

You will need to forward 2 ports:

• Web Server Port you assigned to the NVS.

• Video Server Port you assigned to the NVS.

Both of these ports will be forwarded to the IP address you assigned to the NVS.

In the Case A & B examples above, you would forward:

• 8888  192.168.0.200

• 7777  192.168.0.200

L For information on how to use “Port Forwarding” please read Appendix C

etwork Video Server User’s Manual

B01