User manual

53
You may under certain circumstances see another “new hardware found” dialog box appear after you restart your
computer system because the firmware introduces a new Rev ID, and so to the operating system it is a new device.
1. In the “found new hardware Wizard” dialog box select “install the software automatically” option.
2. Select next.
3. Select “Continue Anyway
4. Select finish
5. Launch Symmetry and the Bluefish444 feature application to test your configuration.
Rage N|Code Installations
If you have installed the Rage N|Code acceleration card for real time HD encoding to MPEG 2 you will be required to install
the Aspex Accelera Installer prior to the Bluefish444 installer.
The Bluefish444 installer requires a pre installed Accelera card and driver to activate the MPEG 2 file format option.
For new installations.
1. Install the Aspex and Bluefish444 card and restart your system
2. Close all “new hardware found” windows
3. Install the Rage Aspect Accelera installer for the RAGE N|Ccode and follow all on board prompts.
4. Install the Bluefish444 installer.
5. Run Symmetry and select file format and confirm the MPEG 2 is a file format options
Installing the Rage N|code after Bluefish444 installation.
1. Uninstall previous Bluefish444 installers
2. Install the Rage Aspect Accelera installer for the RAGE N|Ccode and follow all on board prompts.
3. Re Install the Bluefish444 installer.
4. Run Symmetry and select file format and confirm the MPEG 2 is a file format options