Use and Care Manual

37
MAINTENANCE
7. Check that the pulleys are aligned using a
staright edge along the inside face of the clutch
and pulley.
Pulleys must be inline. Maximum gap or mis-
alignment is 1/16” (.062) or 15.7 mm.
Adjust using the tension bolts as necessary.
Check belt tension again.
8. Tighten all screws and nuts when the
adjustment is complete. Be certain cover plate
is not rubbing against cutter wheel shaft.
9. Refit the belt guard.
8011-229chg
CHECK CLUTCH &
PULLEY ALIGN
USING INSIDE FACE