Owner's manual

15
• Place cross-axle (A) on level surface.
• Insert legs (B) completely, so that latches snap
into holes in the legs. This is important as the
latches keep the legs from pulling out when
the lift is moved.
• Insert upright column post (C) into socket in
cross-axle with flanges facing forward.
• Insert jack handle (F) into handle retainer.
• Hold front end of boom (D) at a high angle and
slide boom hook into the pin on the column
post from bottom side. Lower boom to relaxed
position.
• Bolt base plate to bottom of jack (H).
• Place jack (E) on the pin on column post so
that the pump of the jack (G) next to the col-
umn post.
• Place ram of jack into socket on boom.
• Use level firm surface only.
NOTE: Black pins on cross-axle must be in
DOWN position and IN THE HOLE at rear of
legs. These pins prevent legs from being with-
drawn when moving lift.
ASSEMBLY INSTRUCTIONS