Troubleshooting

8
Troubleshooting
1. How do I re-connect my X3 Headset?
Press the MFB button once shortly to re- connect to the first paired phone.
(Voice dial will be activated if enabled in phone, short press MFB to cancel this). Short
press the MFB and VOL down (-) together to disconnect.
2. Why won’t my X3 micro go into pairing mode?
Follow through the instructions in the X3 micro Manual. Press Volume to enter pairing
mode. If you have already paired 3 different phones to the X3 micro you will need to reset it
to pair a new device. Short press all three buttons on the X3 together to delete pairing
information of all paired devices and enter pairing mode.
Also, the X3 micro sometimes requires a few seconds to establish a connection.
Please be patient while devices are searching.
3. Is my X3 micro charged?
A red light will blink twice every 5 seconds when the battery is low.
A red light will show when the headset is plugged in and charging. It will turn off when fully
charged.
4. Why can’t I hear any sound from the Speaker?
The phone’s memory may have become corrupt and can be fixed by rebooting the phone. I
f this does not resolve the issue Delete the pairing information and re-pair
5. Why is the X3 micro noisy and distorted?
Turn the X3 micro Volume down to a level that does not give echo or feedback. Also turn
the volume down on your phone. A low battery can also cause bad voice quality. Please