Instruction Manual
60°
Installation
• Attach the microphone to the speaker unit via the
“MIC” socket (1a), located at the base of the unit.
(If you wish to use the privacy function, attach
an ear piece via the “EAR” socket (1b)).
• Connect the adaptor lead (2a) to the speaker unit lead
(2b) making sure to line up the arrows. Insert the adaptor
lead connection into the power socket of the phone (2c).
Connection to Power
• Connect the power to the cigarette lighter socket (3a).
• If your cigarette lighter socket is recessed or obscured
please use the BlueAnt Lighter Extension Nozzle (3b).
• Switch your phone back on, and set up an appropriate
profile to use the Safe2Talk unit with. This will make your
phone usage simpler for future in-car use.
• Ensure that accesories power is on or your engine is
running, then insert the speaker unit into the vehicle’s
cigarette lighter socket.
• Ensure that the power is on by pressing the “POWER”
button (4a). Once in use the LED indicator will turn green.
If the unit is in privacy mode, the LED will glow red.
• The volume of the ringing tone will be as usual altered
in the menu of the phone. The speaker unit volume can be
adjusted if necessary by using the volume control (4c).
Important note Ensure the volume of the unit is not turned off.
• The Privacy Mode (4b) channels the audio through an
earpiece diverting it from the speaker unit. To enable
Privacy Mode simply press the button whilst receiving
a call and ensure that an earpiece is attached to
the socket (1b).
Installation of Mobile Phone Holder
• Use the supplied screws to attach holder to dashboard, or alternatively
• Use the supplied double sided bonding tape to secure in position.
Making a call
• Dial desired contact number and press 'call' on your mobile phon, then the audio will
be automatically transferred to the Safe2Talk.
Microphone
• Secure the microphone in one of the
suggested positions (5a or 5b).
• Try to locate the microphone at least 80cm
from the main unit and approximately
20-60cm from the driver’s mouth.
• The microphone is directional and should be
mounted according to Inset (5d) to achieve
the best performance. Avoiding positions
where there may be draught and wind
noise, for example near the side window or
close to ventilation outlet (5c).
• The best position is usually at the top of the
‘A’ pillar (5b), and requires the removal of
lining (6a) which is quite simple. Ensure
there is some slack on the microphone lead
(6b) prior to replacing the drivers side ‘A’
pillar lining when installing the
microphone this way.
Important note
• End cap of the cigarette lighter contains a replaceable
1 Amp fuse (7a). If you remove the end cap be careful
not to lose the internal spring. Please ensure cap is
secured firmly before use.
To further increase safer mobile phone usage BlueAnt recommends the following when using your hands free car kit:
• Avoid heated or stressful conversations.
• Never send or read SMS messages whilst driving.
• Reduce mobile phone usage in heavy traffic or when driving in bad weather.
• Farmiliarise yourself with the features of your mobile phone. One touch dialing, auto answer & voice tags,
minimise distractions associated with making and receiving calls.
Make a good call and always remember that SAFETY is your number one priority.
(1a)
(4a)
(1b)
(3a)
(4b)
(2a)(2c) (2b)
(5c)
(6a)
(6b)
(7a)
(5d)
(5a) (5b)
(4c)
3
4
5
6
7
8
9
(3b)
BlueAnt Lighter
Extension Nozzle
'A' Pillar
(LED)