User's Manual

BlueAnt

Basic Headset Functions

For easy reference, also see the Button/Function Matrix and the Quick Start Guide.

1. Power ON: Press and Hold the BAB for 3 seconds. The solid Blue LED will light up. If the battery is low a solid Red LED will be

displayed. After powering ON, your headset will automatically connect to your last used phone if it is in operating range. If this phone

is not range, the V1 will enter idle mode after 60 seconds. If no phone has yet been Paired, the V1 will enter into Pairing mode.

2. Power OFF: Press and Hold the BAB

for 3 seconds. The Red LED ﬂ ashes three times.

3. Enter Pairing Mode: With the V1 OFF, Press and Hold the BAB

for about 6 seconds until the LED ﬂ ashes Blue. The V1

will stay in pairing mode for 2 minutes then will go into idle mode. To re-enter pairing mode, repeat this step. If you had already

paired 5 devices and want to pair again, you will need to RESET the V1 to enter pairing mode.

4. Make a Call: Dial the number using your phone as normal. Audio will automatically transfer to the headset.

5. To Answer or End a call: Click the BAB

once when there is an incoming call.

Click the BAB

to end the call.

6. Reject*: a call: Press and Hold the BAB

for 1 second when there is an incoming call.

7. Redial*: the last call, Press and Hold the Volume

Button for about 3 seconds. To cancel Redial, click the BAB

8. Activate Voice Dialing*: While connected to a phone, Press the BAB

once. Voice commands must have been

previously recorded into your phone (see your phones user guide for speciﬁ c instructions).

9. Volume level: Click Volume

or Volume during a call to adjust the desired level. Volume changes will be remembered

for the next call. Be sure to use the headset at a comfortable and safe volume level.

10. Disconnect / Transfer: To disconnect the V1 with the currently connect phone Click Volume

and Volume together

once. This will also transfer an ongoing call to the phone.