User Manual
Table Of Contents
- Introduction
- Getting Started
- Using the Q1
- Pairing
- Voice Isolation
- Charging the Q1
- Setting Up Speed Dials
- Troubleshooting
- Q1 Reference
- Safety and General Information
- European Union Directives Conformance Statement
- FCC Notice To Users
- Industry Canada Notice to Users
- Caring for the Environment by Recycling
- Choking Hazard
- Using Ear Gels
- Protect Your Ears
- Care and Handling
- Approved Accessories
- Electromagnetic Interference
- Safety, Warning and Information Symbols
- Smart Practices While Driving
- BlueAnt Limited Global Warranty
9
Use your Voice to Control the Q1
To use the Q1, you just need to remember some simple voice commands.
Every time you want to do something:
1.
Click (the BlueAnt button).
2. Wait for the Q1 to ask you to "Say A Command".
3. Say one of the voice commands loudly and clearly.
• If the Q1 does not respond, say the command again.
• If you wait too long before saying the command, the Q1 will say "Canceled". You will have
to click the BlueAnt button again before you can use another voice command.
• For a full list of voice commands, see "Voice Commands" (page 21).
Try It...
Why not try using the "What Can I Say?" command to hear a list of available voice commands.
With your Q1 switched on, just click the BlueAnt button, wait from the prompt, and then say "What
Can I Say?".
You will hear a list of all the available voice commands.
If you don't want to listen to the full list of commands, you can stop the Q1 from
reading them all out by clicking the BlueAnt button at any time.