User Manual
Table Of Contents
- Introduction
- Getting Started
- Using the Q1
- Pairing
- Voice Isolation
- Charging the Q1
- Setting Up Speed Dials
- Troubleshooting
- Q1 Reference
- Safety and General Information
- European Union Directives Conformance Statement
- FCC Notice To Users
- Industry Canada Notice to Users
- Caring for the Environment by Recycling
- Choking Hazard
- Using Ear Gels
- Protect Your Ears
- Care and Handling
- Approved Accessories
- Electromagnetic Interference
- Safety, Warning and Information Symbols
- Smart Practices While Driving
- BlueAnt Limited Global Warranty
8
• Angle the headset so that it points towards your mouth (this will help the Q1's microphones to
pick up your voice).
Attaching the Ear Hook and Ear Gel
Before you can wear the Q1, you need to attach the ear hook, by pushing the smaller end of the
hook through the hole on the back of the Q1. You can then adjust the length so that the hook will fit
comfortably on your ear.
The Q1 comes fitted with an ear gel. If you want to change the gel, you can remove it by gently lifting it
away from the Q1. Gently press the replacement gel onto the Q1, and push it on firmly to secure it in
place.
Figure1. Wearing the Q1 in your Right Ear
If you prefer to wear the Q1 on your left ear, then you will need to swap the ear hook around:
Figure2. Wearing the Q1 on your Left Ear