User Manual
Table Of Contents
- Introduction
- Getting Started
- Using the Q1
- Pairing
- Voice Isolation
- Charging the Q1
- Setting Up Speed Dials
- Troubleshooting
- Q1 Reference
- Safety and General Information
- European Union Directives Conformance Statement
- FCC Notice To Users
- Industry Canada Notice to Users
- Caring for the Environment by Recycling
- Choking Hazard
- Using Ear Gels
- Protect Your Ears
- Care and Handling
- Approved Accessories
- Electromagnetic Interference
- Safety, Warning and Information Symbols
- Smart Practices While Driving
- BlueAnt Limited Global Warranty
28
Function Button How Long When Notes
Save the last
incoming call in
one of the Q1's
speed dials
Vol- Hold for 1
second
Standby For more information about storing
numbers in the Q1's speed dials, see
"Setting Up Speed Dials" (page 16).
Hold a call
and answer
a second
incoming call
Vol+ Hold for 1
second
3 Way Call This function is only available if your
phone and phone network supports 3
way calling.
End the current
call and answer
a second
incoming call
Vol- Hold for 1
second
3 Way Call This function is only available if your
phone and phone network supports 3
way calling.
Put the current
call on hold and
switch to the
call on the other
line
Vol+ Hold for 1
second
3 Way Call This function is only available if your
phone and phone network supports 3
way calling.
Call Conference Hold for 3
seconds
3 Way Call This function is only available if your
phone and phone network supports 3
way calling.
Reset the Q1
Vol+ and
Vol-
Click all
three
buttons
together
Idle This function is only available when
the headset is in Idle mode. It is not
available when the headset is in Standby
mode, so you will need to disconnect
from all paired mobile devices before
using this button combination.