User Manual
Table Of Contents
- Introduction
- Getting Started
- Using the Q1
- Pairing
- Voice Isolation
- Charging the Q1
- Setting Up Speed Dials
- Troubleshooting
- Q1 Reference
- Safety and General Information
- European Union Directives Conformance Statement
- FCC Notice To Users
- Industry Canada Notice to Users
- Caring for the Environment by Recycling
- Choking Hazard
- Using Ear Gels
- Protect Your Ears
- Care and Handling
- Approved Accessories
- Electromagnetic Interference
- Safety, Warning and Information Symbols
- Smart Practices While Driving
- BlueAnt Limited Global Warranty
26
Function Button How Long When Notes
Reject a Call Double
Click
Ringing You can also answer or reject a call
using the voice commands.
Redial Last
Number
Vol+ Hold for 1
second
Standby/Active
Call
If you use this button function while you
are on an active call, the current call
will be put on hold while the Q1 dials the
last number.
Use Phone
Voice Dialing
Click Standby This function is only available through
this button press if you have turned
off voice control (either through the
"Settings Menu" or by using the button
combination described below).
If voice control is turned on, then you
can access your phone's voice dialing
feature by using the voice command
"Phone Commands" instead.
Switch Voice
Isolation
between
Standard and
Max
Click Active Call/3
Way Call
You will hear an audio confirmation of
the current voice isolation setting when
you switch between them.
Mute Vol+ and
Vol-
Hold
together
for 3
seconds
Active Call/3
Way Call
This function mutes the audio on
the current call. Repeat the button
combination to undo the mute.
Disconnect
the headset
(Transfer audio
back to the
Phone)
Vol+ and
Vol-
Click Standby/
Ringing/Active
Call/3 Way Call
You can use this function to disconnect
the Q1 headset from the phone during
a call. The audio will transfer back to
the phone where you can continue the
conversation.