User Manual
Table Of Contents
- Introduction
- Getting Started
- Using the Q1
- Pairing
- Voice Isolation
- Charging the Q1
- Setting Up Speed Dials
- Troubleshooting
- Q1 Reference
- Safety and General Information
- European Union Directives Conformance Statement
- FCC Notice To Users
- Industry Canada Notice to Users
- Caring for the Environment by Recycling
- Choking Hazard
- Using Ear Gels
- Protect Your Ears
- Care and Handling
- Approved Accessories
- Electromagnetic Interference
- Safety, Warning and Information Symbols
- Smart Practices While Driving
- BlueAnt Limited Global Warranty
25
Active Call
The Q1 is switched on, connected to a mobile device, and there is an active call on the connected
device.
3 Way Call
The Q1 is switched on, connected to a mobile device, and there are two calls on the connected
device (either call waiting, where one call is active and the other is on hold, or a call conference
where all three callers are connected at the same time).
Function Button How Long When Notes
Switch the Q1
On
Hold for 3
seconds
Off You will hear a sound indicating that the
Q1 is switching on.
Switch the Q1
Off
Hold for 3
seconds
Idle/Standby You will hear a sound indicating that the
Q1 is switching off.
Enter Pairing
Mode
Hold for 6
seconds
Off If the Q1 is switched on, then you can
enter pair mode by using the voice
command "Pair Me" instead.
Volume Up Vol+ Click Idle/Standby/
Ringing/Active
Call/3 Way Call
The Q1 will beep when it reaches the
maximum volume.
Volume Down Vol- Click Idle/Standby/
Ringing/Active
Call/3 Way Call
The Q1 will beep when it reaches the
minimum volume.
Activate Voice
Recognition
("Say A
Command")
Click Idle/Standby You need to active voice recognition
in order to use one of the voice
commands (the Q1 will ask you to
"Say A Command"). Click the BlueAnt
button again to cancel (or wait a few
seconds and the voice recognition will
automatically cancel if you do not say
any of the voice commands).
Answer a Call Click Ringing You can also answer or reject a call
using the voice commands.
End a Call Double
Click
Active Call/3
Way Call
The call will also end if the other party
terminates it (you do not need to click
anything if the other party ends the call).