User Manual

23
Command Description
"Sensitivity Level" Use this command to change the sensitivity level of the Q1's voice
recognition. This setting determines how precisely the words that
you say need to match the speech patterns that the Q1 has been
configured to recognize. You can set this to "High", "Medium", or
"Low".
When the level is set to "High" the commands you give the Q1 will
need to match the speech pattern it is expecting more exactly,
while "Low" is less restrictive and will accept your commands
even if they don't precisely match the expected speech pattern.
If you find that the Q1 is not recognizing your voice commands at
all, you should change to a lower sensitivity level.
You may wish to switch to a higher sensitivity level if the Q1 often
responds to your voice commands by carrying out the wrong
command.
"Incoming Call Function" Use this command to turn the incoming call function on or off.
If you turn the incoming call function off, then the Q1 will not
announce the number of any incoming calls, and you will not be
able to answer calls using your voice.
"Say A Command Prompt" Use this command to turn the "Say A Command" prompt on or off.
If you turn off the prompt, you will hear a beep instead.
"Turn Off Voice Control" Use this command to turn off voice control. If you turn off the
voice control, then you will only be able to control the Q1 using the
buttons. See "Button Functions" (page 24) for a full list of the
available controls.
"LED Light" Use this command to turn the LED Light on or off.
When you turn the LED off, it will still light up when you turn the
Q1 on and off, but will not flash at other times.
You might want to turn off the LED light if you find it distracting,
for example if you are using the Q1 while driving at night.
"Reset the Q1" Use this command to reset the Q1. All stored pairings will be
deleted, and the Q1 will go back to pair mode.