User Manual
Table Of Contents
- Introduction
- Getting Started
- Using the Q1
- Pairing
- Voice Isolation
- Charging the Q1
- Setting Up Speed Dials
- Troubleshooting
- Q1 Reference
- Safety and General Information
- European Union Directives Conformance Statement
- FCC Notice To Users
- Industry Canada Notice to Users
- Caring for the Environment by Recycling
- Choking Hazard
- Using Ear Gels
- Protect Your Ears
- Care and Handling
- Approved Accessories
- Electromagnetic Interference
- Safety, Warning and Information Symbols
- Smart Practices While Driving
- BlueAnt Limited Global Warranty
21
Q1 Reference
This section contains detailed reference information about the Q1, including full lists of all the
available button functions and voice commands.
Voice Commands
You can use the following voice commands to control your Q1.
Command Description
"Am I Connected?" Use this command to find out if the Q1 is connected to your phone.
If you have paired your phone with the Q1, but it is not currently
connected, then saying this command will cause the Q1 to attempt
to connect.
"Answer" Use this command to answer an incoming call.
Before you can use this command, you must wait for the Q1 to
read out the phone number and ask you whether you want to
answer the call.
You cannot answer or ignore a call with your
voice if you have turned off the "Incoming Call
Function" in the "Settings Menu".
"Call Back" Use this command to call back the last incoming call you received
on the currently connected phone. Please note that this is the last
incoming call received on the phone while it was connected to the
Q1.
"Call Speed Dial 1" to "Call
Speed Dial 8"
Use these commands to call the corresponding speed dial stored
on your phone.
For example, say "Call Speed Dial 3" to call the number stored in
speed dial 3 on your phone.
You can also set up speed dials in your Q1 headset itself. For more
information, see "Setting Up Speed Dials" (page 16).