User Manual

19
2.
Press (the BlueAnt button), the volume up, and the volume down button once together.
You will hear a message telling you that the Q1 has been reset, and the device will go straight to pair
mode. Follow the voice prompts to pair the Q1 with your phone.
My Phone Does Not Automatically Reconnect to the Q1
Once you have paired your phone with the Q1, they should automatically reconnect every time they
come back into range with each other.
On some phones you need to change a setting before they will automatically reconnect to the Q1.
If your phone keeps prompting you to confirm whether you want to accept the connection from the Q1,
then you should change this setting on your phone.
Configuring Your Phone To Automatically Reconnect to the Q1
1. Go to your phone's Bluetooth menu.
2. Locate the BlueAnt Q1 in the list of paired devices, and go to the options or device property
settings.
3. The exact option to change will depend on your phone model, but look for the option to set this
device as an authorized device, or add it to your phone's list of trusted devices.
The Q1 Keeps Switching Itself Off
If the battery on the Q1 gets very low, the Q1 will automatically turn itself off.
You should charge your Q1 using the supplied USB cable and adapter.
The Q1 does not Respond to my Voice Commands
If you find that the Q1 does not recognize your voice commands, try the following tips:
• Make sure you say the command clearly, speaking at a consistent speed.
• If the headset does not respond, repeat the command.
• There is a microphone on the bottom tip of the Q1. Make sure that it is pointing towards your
mount and that it is not covered or muffled by your cheek.