User Manual
Table Of Contents
- Introduction
- Getting Started
- Using the Q1
- Pairing
- Voice Isolation
- Charging the Q1
- Setting Up Speed Dials
- Troubleshooting
- Q1 Reference
- Safety and General Information
- European Union Directives Conformance Statement
- FCC Notice To Users
- Industry Canada Notice to Users
- Caring for the Environment by Recycling
- Choking Hazard
- Using Ear Gels
- Protect Your Ears
- Care and Handling
- Approved Accessories
- Electromagnetic Interference
- Safety, Warning and Information Symbols
- Smart Practices While Driving
- BlueAnt Limited Global Warranty
13
2. Bring the mobile phone to within about 30cm of the Q1.
3. Find the Bluetooth menu in your mobile phone, and turn Bluetooth on.
If necessary, refer to your phone's manual, or check with your phone manufacturer for more
information on how to enable Bluetooth on your mobile phone.
4. Use your phone's Bluetooth menu to search for Bluetooth devices.
This may take a few minutes, depending on your phone model.
5. When your phone finishes searching, it will display a list of devices it has found. Select the
BlueAnt Q1 from the list.
6. If your phone prompts you for a password or security code, enter "0000".
7. Depending on your phone model, it may now connect to the BlueAnt Q1 automatically. If this
does not happen, select the option on your phone to connect to the Q1.
You are now ready to start using the Q1.
On some phones you may need to change an additional security setting to allow the
phone and headset to reconnect to each other automatically every time they come
back into range.
If your phone keeps prompting you to accept the connection from the Q1, then this
applies to you. See "My Phone Does Not Automatically Reconnect to the Q1" (page
19) for more details on how to fix this on your phone.