User Manual
Table Of Contents
- Introduction
- Getting Started
- Using the Q1
- Pairing
- Voice Isolation
- Charging the Q1
- Setting Up Speed Dials
- Troubleshooting
- Q1 Reference
- Safety and General Information
- European Union Directives Conformance Statement
- FCC Notice To Users
- Industry Canada Notice to Users
- Caring for the Environment by Recycling
- Choking Hazard
- Using Ear Gels
- Protect Your Ears
- Care and Handling
- Approved Accessories
- Electromagnetic Interference
- Safety, Warning and Information Symbols
- Smart Practices While Driving
- BlueAnt Limited Global Warranty
12
Pairing
Before you can use the Q1 headset, you need to pair your phone with the Q1.
Pairing creates a stored link between the phone and the headset. Once you have paired your phone
with the Q1, they will reconnect to each other in future without you having to repeat the pairing
process.
To pair your phone, use the "Pair Me" command and follow the voice prompts. The instructions below
provide some additional information about the pairing procedure, in case you encounter problems
pairing your phone with the Q1.
• The Q1 can store pairing information for up to 8 different Bluetooth devices.
• Up to 2 devices can be connected at the same time (multipoint). When two devices are
connected, you can answer whichever one rings.
• If a mobile device is connected to the Q1 and you go into pair mode to pair another device, then
the first device will disconnect from the Q1.
Pairing Procedure
1.
With the Q1 switched on, press (the BlueAnt button) and use the "Pair Me" command to enter
pair mode.
The voice prompts will explain that the Q1 is now in pair mode.