Specifications

Installation
1. INDOOR USE ONLY
• This unit is intended for indoor use only.
2. LOCATION
• Be sure that the location is strong enough to support the total weights of the unit and its contents.
• Keep the unit away from sunlight and other heat generating equipment.
• The minimum clearance between the back of the unit and the wall should be at least 7 inches.
3. INSTALLING CASTORS
• Ensure that castors with brake are installed in front.
4. LEVEL
• The unit should be level to provide adequate drainage.
5. ELECTRICAL CONNECTION
• The unit should be plugged into a 115V/60Hz, grounded wall receptacle to prevent
electrical shock and fire hazards.
• Do not plug other electrical units into same wall receptacle this unit is plugged into.
• Do not use an extension cord.
• Compressor warranties are void if the compressor burns out due to low voltage.
6. INSTALLING SHELF
• Install shelves using shelf-clips provided.
Maintenance & Cleaning
1T iti fi ti f th d fi h ldb
1
.
T
o ma
i
n
t
a
i
n proper re
f
r
i
gera
ti
on per
f
ormance,
th
e con
d
enser
fi
ns s
h
ou
ld
b
e
checked monthly and cleaned with a soft brush or vacuum cleaner as needed.
2. Wait at least 6 minutes after unplugging the unit before replugging it in.
3. The interior and exterior of the unit can be cleaned with mild detergent and water.
• Do not use abrasive cleaners to avoid scratching the unit.
4
4. The door-gasket should be cleaned to maintain proper seal.