Specifications

29
speed, which is recommended for fast initial cleaning, daytime use, or much polluted air. After a few
minutes, adjust the control to the desired speed. Minimum speed is generally recommended for
nighttime use.
E Series settings
Power On/Off•
Press the green “Power” key to turn the unit on and off. The unit automatically runs on the high-
est speed for fi ve minutes after it is turned on to provide fast initial cleaning and then switches
to Auto Mode.
Speed•
Press the “Speed” key to regulate operating speed manually.
– Use Speed 1 for nighttime use.
– Use Speed 2 for daytime use.
– Use Speed 3 for fast initial cleaning or for larger rooms.
– Use Auto Mode to let the electronic gas and particle sensors automatically adjust the operat-
ing speed according to the level of particles and gaseous compounds in the air.
Preset•
When the unit is turned off, use the “Preset” key on the remote control to set “On Time”, “Off
Time“ and “Speed”.
– “On Time”
Press the “Preset” key once. Set the “On Time” by using the plus (+) and minus (–)
keys to add or subtract time in intervals of 30 minutes. The display will indicate the amount of
time (for instance, 1 for one hour) and count down to zero, when the unit will turn itself on.
– “Off Time”
Press the PRESET key again. Set the OFF TIME using the plus (+) and minus (–)
keys to add or subtract time in intervals of 30 minutes. The display will indicate the amount of
time (for instance, 4 for four hours) until the unit will turn itself off. If ON TIME is set at 1 and
OFF TIME is set at 4, the unit will turn on after 1 hour and turn off after 4 hours of operation.
Care and maintenance
Blueair air purifiers feature high quality design, materials and workmanship. To keep your unit in top
condition, we recommend routine cleaning. The appliance must be disconnected from the supply
mains before cleaning or maintenance.
Vacuum the air intake grille from the inside when you remove the filters to replace them.•
Vacuum the small inlets with a soft brush attachment.•
Wipe the exterior of the unit with a soft, clean, damp cloth. •
Never clean with gasoline, chemical solvents or corrosive material also as these agents may •
damage the surface.