Specifications

28
User manual
The following instructions are rendered in the user manuals. They are good to know for general safety
instructions, settings, how the units work and how to change filters.
General safety instructions
Blueair air purifiers are electrical appliances. Please read the safety instructions before use and take
the necessary precautions to reduce the risk of fire, electric shock or injury. The Blueair Limited
Warranty applies only if the unit is used according to these instructions.
Use the grounded power cable provided with your Blueair unit. The plug fits into a grounded •
outlet. Do not alter the plug in any way.
Use the cable provided to plug the Blueair unit directly into an appropriate electrical outlet (please •
refer to the voltage label on your unit). The cable is packaged beneath the unit.
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance. If the supply cord
is damaged, it must be replaced by the manufacturer or its service agent or similarly qualified persons
in order to avoid a hazard.
Placement
Place the unit in a location that allows air to circulate freely in, out and around the unit. The minimum
acceptable distance from another object is 4” or 10 cm. Use only genuine Blueair filters. Do not place
the unit:
Directly on or against soft furnishings, such as bedding or curtains.
Near sources of heat, such as radiators, fireplaces or ovens.
Near wet areas, such as bathrooms or laundry rooms, where it may come into con-
tact with water.
Outdoors.
Manual settings
Plug the power cable firmly and completely into the recessed power cord socket located at the bot-
tom of the unit and plug the other end into a grounded wall outlet or power strip. Turn on your Blueair
unit. The blue light-emitting diode indicates that the unit is working. Set the control knob to maximum