User Manual

2 3

DESKTOP MOUNTING INSTRUCTIONS

Mount Compass to your desktop via the included C-clamp:

Fixed mounting with the

desk-insert bushing

(sold separately, see bluedesigns.com)

If you would like to permanently mount

Compass to your desktop, please use

the following procedure:

Using an electric drill and a 1-inch hole saw bit, drill

a hole into the desktop at least 2.5inches from the

edges of the desk.

Unscrew the nut from the desk-insert bushing and

insert the bushing into the hole.

Screw the nut onto the bushing from the underside

of the desktop until it is tight and secure.

Lower Compass into the desk-insert bushing until it

is secure and rotates smoothly in both directions.

Unscrew the C-clamp and

slide it over the side of your

desktop, making sure that

both the top of the C-clamp

and the underside are

resting on ﬂat surfaces.

Overly rounded or

overhanging desktop

edges do not make good

mounting surfaces.

Screw the lower part

of the C-clamp until it

is tight and secure.

Lower Compass into the C-clamp until it is

secure and rotates smoothly in both directions.

2.5in

1 2