Owner's manual

PAGE 1
Assembly Instruction I. Preparation of Your Pool Before assembling and installing your cleaner,your pool should be clean and algae-free so as not to inhibit the cleaner’s traction, If necessary, make the following preparations before proceeding: 1. Chemically balance the pool water. 2. Brush pool and let the debris settle. 3. Hand vacuum thoroughly. 4. Clean filter Il. Assembly Remove the body and all of its parts from the box and check sure that all components were included. Refer to Figure 1.
PAGE 2
CONE \ Twist and push the female ends onto the male ends after dipping the ends into the pool to wet them. See Figure 3. Continue until you've connected all the sections you need. then connect the HOSE to the cleaner. One of the hose sections has 2 female ends Your fully assembled cleaner should look like this. 11*F*M Fig #3 Male Hose End Female Hose End filters with 1500 gallon’s or less,close regulator valve 100% 2.