MSDS

SAFETY DATA SHEET
Date Issued :
07/24/2009
MSDS No :
Blue Wave Halt 50
Date Revised :
06/27/2012
Revision No :
3
Blue Wave Halt 50
ENGINEERING CONTROLS: In processes where mists or vapors may be generated, proper ventilation must be provided in accordance with
good ventilation practices.
PERSONAL PROTECTIVE EQUIPMENT
EYES AND FACE: Wear tightly fitting safety goggles and face shield.
SKIN: Nitrile rubber gloves with break through time greater than 480 min
RESPIRATORY: In misty conditions, use a respirator with approved filter.
PROTECTIVE CLOTHING: Rubber or plastic apron and boots.
WORK HYGIENIC PRACTICES: Avoid contact with skin, eyes and clothing. Wash after handling.
9. PHYSICAL AND CHEMICAL PROPERTIES
ODOR: Ethanol-like
pH: 6.5 to 9.0 10% active solution
VAPOR PRESSURE: Not Known
VAPOR DENSITY: 0.93 g/cm3
Notes: at 77 degrees F (25 C)
BOILING POINT: Not Known
FREEZING POINT: -20°C
FLASHPOINT AND METHOD: (109°F) SETA Flash Tester CC
SOLUBILITY IN WATER: Soluble
EVAPORATION RATE: Not Known
VISCOSITY #1: < 100 mPa. s. at 25°C (77°F)
10. STABILITY AND REACTIVITY
STABILITY: Stable.
POLYMERIZATION: Will not occur.
CONDITIONS TO AVOID: None known.
HAZARDOUS DECOMPOSITION PRODUCTS: Nitrogen oxides (NOX); hydrochloric acid; carbon oxides.
INCOMPATIBLE MATERIALS: Strong oxidizing or reducing agents.
11. TOXICOLOGICAL INFORMATION
ACUTE
DERMAL LD
50
: 4300 mg/kg (rabbit)
ORAL LD
50
: 450 mg/kg (rat)
EYE EFFECTS: Severely irritating (rabbit).
SKIN EFFECTS: Corrosive (rabbit) 4 hr, Method:OECD Test Guideline 404
SENSITIZATION: (guinea pig) Not a sensitizer.
Page 3 of 6