Use and Care Manual
5
SETUP INSTRUCTIONS
Ination Instructions
CAUTION: Inatebyadultonly.DO NOToverinateoruseahighpressureaircompressortoinate.
Inatethepoolwithcoldaironly.
1.Locateacleanareafreeofstonesorothersharpobjectstoinatethepool.
2.Inatetheairchambersfollowingthenumberedsequence(ifany)slowlywithamanual/footair
pump.
Adequate air pressure:makesurethepoolisrmtothetouchbutNOThard-thereshouldbe
smallfoldsaroundthearmrests,backrestsand/orsideedges,andbelowthecupholders(ifany).
Also compare the pressure with that of the large main chamber.
3.Closeandpresstheinationvalvesintotheunittogetaatsurface.
4. Check regularly to ensure the adequate air pressure during each use, especially on very hot or cold
days.
Emptying And Deating the Pool: Deatethepooland/orpushdownonthesidewallto
emptythepoolwaterand/orliftuponesideofpooltoemptypoolwater
NOTE: 1. The pool can be only cleaned with mild soap and lukewarm water.
2. Make sure the pool is completely dry before storing to help prevent mildew from forming.
3. Store all parts in a dry, temperature-controlled area where temperatures do not go
below 32ºF or above 125ºF.
4. Use a small patch kit to repair punctures or holes in pool.
Repair
1. Use a mix of liquid dish soap and water in a spray bottle, and spray over suspicious areas. Any leak
will produce bubbles that will pinpoint the location of the leak.
2. Thoroughly clean the area surrounding the leak to remove any dirt or grime.
3. Cut a piece of repair patch (included) with a margin of 0.8” (2 cm) larger than the damaged area,
rounding the corners with scissors.
4.Placethepatchoverthecenteroftheleak,pressdownrmly,andsqueezeoutallairbubblesto
the edges. You may want to put a weight on top to keep it in place.
5.Donotinateforonehourafterpatching.
NOTE: if the patch does not hold, you can use the patch with silicone- or polyurethane-based glue
designedforrepairingcampingmats,tents,orshoes.Consultyourlocalhousehold/camping
supply stores, and follow the instructions of the glue you’ve chosen.