Operating Guide

8SAVE THESE INSTRUCTIONS
7. TROUBLESHOOTING
Problem Possibilities/Solutions
Does not appear to be heating
the pool
•Checktomakesurethatwaterisflowingthroughthewaterchannels.Checktheflow
strength at the pool inlet.
•Hasitbeensunny?
•Putyourpoolcoveronatnighttopreventheatloss.
•Additionalheatersandbypasskitmaybenecessary.
No initial bubbling after heater is
connected and pump is on
•Checkthesettingofthefiltertomakesureitisreturningwatertothepoolthroughthe
pool water inlet.
•Checkflowrate.
Bubbles continue to flow out of the
pool water inlet well after the pump
has been turned on
•Checktheconnectionsforasuctionleak.
•Checktomakesuretheflowrateisnormal.
•Therecouldbeabreakinthetubing.
•Therecouldbeacloginthetubing,trytopurgeout
the clog.
Dripping or leaking from connectors
•Checktheconnectorsealsando-ringsandreplaceorrepairifdefective.
•Iftheheaterispunctured,usetheincludedrepairkit,orakitmadeforPVCpoolor
waterbed repair, to patch the puncture.
•Tightentheelbowconnectorsbyhand.
•Coatallsealsando-ringswithathinlayerofgasketlubricant,availableatyourlocal
hardware or pool store.
High pump pressure •Flowthroughheatermaybetoohigh.Abypasskitmaybeneeded.
•Filtermayneedtobereplaced,cleanedorbackwashed.