Owners manual

ASSEMBLY INSTRUCTIONS
1.
2.
4
Table Tennis Surface A (#1)
Washer H ea d Scre w (#5)
Table tennis Join t (#6)
Table Tennis Surface B (#2)
#1
#2
Table tennis Join t (#6)
Was her H ea d Scre w (#5)
Felt pad (#4)
Assemble the table tennis surface A(#1) and table tennis surface B(#2) together with steel joint #6 and
screw #5 as below.
Remove the paper on the felt pad #4 and stick the pad #4 to the corners of the
table tennis surface as below.
Put the assembled table tennis surface on the table surface carefully, then clip the net post clip and
net on the tennis surface as show as below.
B
A
A
B
NOTE: Be sure to measure surface table is to be placed on, so felt pads #4 are positioned to contact this surface.
NOTE: If table is used over billiard table it is recommended that a small block equal to the rail height be placed under
the center of the table tennis surface to prevent the table from sagging.