Use and Care Manual

8
If you are connecting your pump to a 110V power source follow these simple
directions. Remove the rear housing cover to expose the electric connection plate
5
1
4
2
6
Move the white wire (not your power cord white) —the short white wire inside
the motor housing- from the current location to the clip pin located in the center
of the connection plate. You can use pliers to pull the clip from its original
location and slide it onto its correct position
Move the black wire (not your power cord) —the short black wire located inside
your motor housing- from its current location and slide it onto the hub located
on the right side of the connection plate
DO NOT MOVE THE BROWN WIRE
Take one of your wire leads from the power source —the color does not matter
(do no use ground green wire)— and connect it to the wire hub next to the
existing white wire. If your power source wire has a clip on the end you can
slide it onto the hub pin
Take the second power source wire and connect it to the hub next to the
brown wire connection
Take your power source ground wire (green) and connect it to the grounding
screw located near the center of the motor
Replace housing cover
1
2
3
4
5
6
7
ATTENTION LICENSED ELECTRICIANS
STANDARD WIRING FOR 110V
— See Motor Label for Details —