Use and Care Manual

ATTENTION LICENSED ELECTRICIANS

STANDARD WIRING FOR 220V

— See Motor Label for Details —

If you are connecting your Pump to a 220V power source follow these

simple directions. Remove the rear housing to expose the electric connection plate

Your New Pump is pre-wired for 220V operation

You will attach the 2 power supply wires and the ground wires as

indicated below

One on the 2 power wires-line 1 (doesn’t matter which one or what

color) connects to the Top left connection hub — you can use a clip

and slide it on or loosen the nut and attach the wire direct to the port

Connect second power wire (line 2) to the connection hub to the

right of the first connection. Again you can slide on a clip connection

or loosen the nut and attach the wire direct. Once again the color of

the line in does not matter

Attaching the ground wire (green) Take the 3rd wire from your power

source (green) and attach it to the grounding screw located at the

center of the motor

Replace the housing cover